This Is an Acid-Based Product Primarily Intended for Use on Man Made Tile & Grout
It Will Etch Calcium-Based Stones (Travertine, Limestone, & Marble)
Stone Pro Quick Clean is a hydrocloric acid-based tile and grout cleaner specifically formulated to handle the toughest jobs. It makes short work of dirty grout lines and tiles, grout haze, calcification, and efflorescence - while tackling even the worst dirt and grime. Quick Clean may also be used to safely remove calcification from most granite surfaces.
Quick Clean is the no-nonsense solution to your heavy tile and grout cleaning problems. It can be used safely on ceramic tile, porcelain tile, grout, granite, masonry, pavers, Saltillo, brick, and most other man made surfaces.
Stone Pro Quick Clean can be neutralized by using diluted Stone Pro Deep Clean Gel.
Quick Clean will etch all calcium-based stones on contact, including travertine, marble, and limestone.
Caution: Contains hydrochloric acid. Extremely dangerous if swallowed. Will cause skin and eye irritation on contact. The use of safety equipment is strongly recommended. Chemical resistant gloves and eye protection should be worn at all times when using this product.
Glass, metal, wood, and plants should be protected from exposure to this product.
Stone Pro and Terra BioCleans' liability, either expressed or implied, is limited solely to the replacement of this product when proven to be defective, and does not include any labor costs or consequential damages. It is the user's responsibility to determine the safety, toxicity, and suitability of this product. Person(s) testing for desired results and effects to determine suitability of this product for any intended or unintended purpose shall be solely responsible for any outcome related to the use of this product. Coverage: Product will cover approximately 50 to 500 ft.˛ per quart dependant on the severity of surface soiling. Directions: - Apply product to an inconspicuous area to test suitability for intended use.
- Wet the surface are to be cleaned.
- Dilute Quick Clean with cold tap water per instructions on the bottle. NOTE: Always add Quick Clean to water, NOT water to undiluted Quick Clean - this will ensure no unintended spattering of product.
- Apply properly diluted Quick Clean to the surface and agitate thoroughly with with a bristle brush or floor machine equipped with an acid-resistant brush or cleaning pad. Grout lines should be agitated thoroughly with a grout brush.
- Allow the product to dwell for approximately 10 minutes after agitation. DO NOT LET DRY ON SURFACE.
- Remove product from the surface and rinse thoroughly with cold water.
- Repeat as required to obtain desired result.
- NOTE: Porous surfaces requiring sealing after cleaning should be neutralized with Stone Pro Deep Clean Gel and rinsed prior to applying sealer.
SECTION I - PRODUCT IDENTIFICATION
TRADE NAME: Stone Pro Quick Clean PRODUCT CODE: SPQC
CHEMICAL NAME: Acrylic blend CAS #: Blend, no single CAS # applies DOT HAZARD CLASS: NA 1760 DATE: February 19, 2005
DOT SHIPPING NAME: Quart: ORM-D Gallon: NA1760
SECTION II - HAZARDOUS INGREDIENTS
HAZARDOUS INGREDIENTS CAS # TLV (UNITS) PEL
Hydrochloric Acid 7647010 5 PPM 5 PPM
SECTION III - PHYSICAL DATA
BOILING POINT: (F) 212 SOLUBILITY: Complete pH: <1
VOC: 30 g/L VAPOR DENSITY: N/A VAPOR PRESSURE: N/A
EVAPORATION RATE (WATER = 1); >1 SPECIFIC GRAVITY: 1.1
APPEARANCE & ODOR: Colorless liquid with acrid odor.
SECTION IV - FIRE AND EXPLOSION HAZARD INFORMATION
FLASH POINT: N/A
FLAMMABLE LIMITS: N/A LOWER: N/A UPPER: N/A
FIRE/EXPLOSION HAZARDS: None
EXTINGUISHING MEDIA: Foam, CO2, dry chemical
FIRE FIGHTING PROCEDURES: Fire fighters should wear self-contained breathing apparatus and full protective clothing. Use water spray to cool nearby containers and structures exposed to fire.
SECTION V - HEALTH HAZARD INFORMATION
PERMISSIBLE EXPOSURE LEVEL: ND
EYES: Will cause irritation and redness.
SKIN: Severe irritation.
INHALATION: Inhalation of mist may cause respiratory irritation.
INGESTION: Will cause severe gastrointestinal irritation.
THIS MATERIAL IS NOT LISTED AS A CARCINOGEN BY IARC, NTP OR OSHA
HMIS HAZARD CLASS: Health = 2 Flammability = 0 Reactivity = 0 Other =NA
Ranking: 0 = Least 1 = Slight 2 = Moderate 3 = High 4 = Extreme
FIRST AID
EYE CONTACT: Flush with water for 15 minutes lifting eyelids. Get medical attention immediately
SKIN CONTACT: Wash with water and treat with any moisturizing cream.
INHALATION: Remove victim to fresh air. Administer artificial respiration if breathing ceases. Get medical attention immediately.
INGESTION: Do not induce vomiting. Give lots of water. Give milk of magnesia. Call a physician.
SECTION VI - REACTIVITY INFORMATION
STABILITY: Stable
REACTIVITY: None will occur
HAZARDOUS DECOMPOSITION INGREDIENTS: N/A
HAZARDOUS POLYMERIZATION: Will not occur
SECTION VII - SPILL, LEAK AND DISPOSAL PROCEDURES
SMALL SPILLS: Mop, sweep or absorb. Transport to non-hazardous land fill.
LARGE SPILLS: Mop, sweep, or absorb. Transport to non-hazardous land fill.
DISPOSAL: Dispose of in accordance with federal, state, and local regulations.
SECTION VIII - SPECIAL PROTECTIVE EQUIPMENT
EYE AND FACIAL: Wear chemical splash goggles.
SKIN: Vinyl, rubber, or nitrile gloves should be used.
RESPIRATORY: Provide OSHA approved mists respirator.
VENTILATION: Local mechanical ventilation to keep TLVʼS below recommended levels.
OTHER: Wear protective apron, boots, and clothing.
SECTION IX - SPECIAL PRECAUTIONS
STORAGE: Store in cool dry well ventilated place
HANDLING: Do not mix with other chemicals.
LEGEND: ND, Not Determined; N/A Not Applicable; NA, Not Available.
NOTICE
All information appearing herein is based upon data obtained from chemical manufacturers and or recognized technical sources. While the information is believed to be accurate, Snyder Manufacturing Corporation
makes no representations as to its accuracy or sufficiency. Conditions of use are beyond Snyder Manufacturing Corporationʼs control and therefore users are responsible for and assume all risks of their use, handling,
and disposal of the product, or from the publication or use of, or reliance upon, information contained herein. This information relates only to the product designated herein, and does not relate to its use in combination
with any other material or in any other process
|
