Coverage: Product will cover approximately 200 to 1,000 ft.² per gallon dependant on the porosity of the surface. Two coats are recommended to independantly achieve maximum water repellancy; color enhancement is usually achieved with a single coat. Allow minimum of 24 hours between coats; full cure is achieved in 72 hours.

Directions:

Always test product in an inconspicuous area to test suitability for intended use. 

Surface must be sound, thoroughly clean, and free from waxes, sealants, or coatings of any kind. For best results, use Stone Pro Deep Clean Gel to remove soil and embedded dirt, or Formula 51 Stripper to remove waxes or topical coatings before applying Color Enhancer.

Apply product evenly using a low-pressure sprayer or lamb's wool applicator. Do not dilute in any way. Please wipe off any excess residue after applying each coat. Excess residue may become slippery.

If complete hydrophobic (water) and/or oleophobic (oil) protection is required, apply a coat of Stone Pro Porous Pro Impregnator after the application of Stone Pro Color Enhancer

Caution: Combustible. Keep away from heat, open flame, sparks and/or any possible ignition source. Keep work area well ventilated. Gloves and goggles should be worn at all times. Respirator suggested in larger areas or non-ventilated areas. Read directions and other cautions on back of container before use of this product.